Solved prints bubble up

i just got printing a week or two ago and got pretty good prints for a while now all the sudden the prints are starting to look like this any advice would be greatly appreiciated

 

We can't see your image. Try uploading it again.

 

oh ya sorry by this was pla on cura

 

So you are referring the bubbling of your brim? It clearly is having poor bed adhesion. Assuming it is an R1, have you tried cleaning the glass and adding a little bit of hair spray?

 

i had used glue but that worked way better thanks

 

Excellent. I have found hair spray to be the easiest. But glue works, but you need to water it down to be thin. I have an extra piece of glass on my bed. But I found if I use hair spray and let it come back to room temperature almost all print pop us by themselves.