1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved y axis moving wrong way while homing

Discussion in 'Troubleshooting' started by gunsmoke132, Apr 18, 2018.

Page 2 of 2
  1. gunsmoke132

    gunsmoke132 Member

    Joined:
    May 13, 2016
    Messages:
    183
    Likes Received:
    14
    how would i "shorten the y-axis because nothing is in the way.
     
    #21 gunsmoke132, Apr 19, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    The positions of the bed probing are in the firmware.
    If that is what is not working then you have a problem that needs addressing.
    If the slicer were doing it then you could just shorten the Y axis in the slicer configuration, but since autoleveling is doing it you have a problem with the Y axis. Either HOME is not really homing all the way or there is something blocking travel. It is unlikely that your firmware is somehow specifically configured so that the Y axis is incorrect :) If you didn't modify the firmware that is...
     
    #22 mark tomlinson, Apr 19, 2018
  3. gunsmoke132

    gunsmoke132 Member

    Joined:
    May 13, 2016
    Messages:
    183
    Likes Received:
    14

    welp i tryed the classic "turn it off and drain the caps and reboot" approach and it seems to be working. idek. I'm a comp sci major and electronics never cease to amaze me.
     
    #23 gunsmoke132, Apr 19, 2018
    mark tomlinson likes this.
Page 2 of 2

Share This Page