1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Wow..simplify3d and R1+ works well!

Discussion in 'Show and Tell' started by Jerry Normandin, Jan 19, 2018.

  1. Jerry Normandin

    Joined:
    Jan 4, 2018
    Messages:
    26
    Likes Received:
    32
    I configured Simlify3Dfor my new R1+. Wow!
    I will post my RoBot
    Chassis soon.
    I printed the side panels with both mattercontrol and simplify.. what a difference. The interlocking notches on my print don't need rework on the simplify3d side and the glass side of the print is ultra smooth.
    The prints take just about the entire print volume.

    I am printing the upper panels and lower panels tonight.

    When complete I will have a ROS controlled Rover.
     
    mark tomlinson, WheresWaldo and Geof like this.
  2. shmoe01

    shmoe01 New Member

    Joined:
    Nov 28, 2017
    Messages:
    14
    Likes Received:
    2
    that sounds pretty awesome. Did you try Cura or overall just better success with Simplify3d?
     
  3. Jerry Normandin

    Joined:
    Jan 4, 2018
    Messages:
    26
    Likes Received:
    32
    I owned Simplify 3D. My first 3D printer was a Wanhao Duplicator I3. Bought that 2 years ago.
     
  4. Susanne Adam

    Susanne Adam New Member

    Joined:
    Jul 18, 2019
    Messages:
    12
    Likes Received:
    0
    Wanhao Duplicator I3 is also considered to be a good 3D printer in use.
     

Share This Page