1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Fine tuning fine printing

Discussion in 'Off Topic' started by mark tomlinson, May 25, 2018.

  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Interesting video:

     
    #1 mark tomlinson, May 25, 2018
    DrOldies and bill Snyder like this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Still like our resin printer for the really small stuff :) But we have gotten quite passable results on the Robos
     
    #2 mark tomlinson, May 25, 2018
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    The presenter is a bit annoying to watch, but he does get the basics covered :)
    Any of these FDM printers with stock hardware and nozzles can do really decent prints.
     
    #3 mark tomlinson, May 25, 2018
  4. DrOldies

    DrOldies New Member

    Joined:
    Jun 10, 2018
    Messages:
    1
    Likes Received:
    0
    While this video is dated, showing lots of models up close is very helpful. Most videos show them from several feet away. Including a number of settings and the results will save lots of time.
     
    #4 DrOldies, Jun 17, 2018

Share This Page