1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

source for R2 belts?

Discussion in 'Troubleshooting' started by Steve pointon, Jan 20, 2019.

  1. Steve pointon

    Steve pointon New Member

    Joined:
    May 18, 2013
    Messages:
    12
    Likes Received:
    0
    i was finally replacing my rear left bearing today and realized that the short drive belt on that corner is badly worn due to debris from the bearing disintegration on that side contaminating the belt and pully. I looked up what is the belt code and could not find a co-responding belt?
    I did find this one on amazon and was wondering if it is the correct size?


    https://www.amazon.com/RobotDigg-19...7419&sr=1-1&keywords=192mm+2mm+belt+6mm+width

    also what is the correct spec for the main belts
     
    #1 Steve pointon, Jan 20, 2019
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    I think the belt is 600 mm, it would be best to ask Robo directly. They have never published a parts list.
     
    #2 WheresWaldo, Jan 20, 2019
    Last edited: Jan 22, 2019
    Geof likes this.
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Ditto, no idea on the belt- havent replaced one on any of my R2/C2 machines yet.
     
    #3 Geof, Jan 22, 2019
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Hey Steve,
    Saw your conversation on Facebook with the same question. They had an answer from Robo there (not sure who- hate facebook so just skimmed until I found the answer by happenstance)

    R2 Gantry XY Belt 600mm - $2.38/ea plus shipping (you will need 4 of these)
    R2 Motor Belt 192mm - $1.00/ea plus shipping (you will need 2 of these)

    Otherwise, you could source them yourself. They are GT2 closed loop belts. (lengths are noted above and printed on the belts themselves)
     
    #4 Geof, Jan 22, 2019
  5. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Good, I fixed my post above.
     
    #5 WheresWaldo, Jan 22, 2019

Share This Page