1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

R2 Probing error . self leveling

Discussion in 'Troubleshooting' started by Cindy C, Feb 18, 2019.

  1. Cindy C

    Cindy C New Member

    Joined:
    Dec 28, 2018
    Messages:
    1
    Likes Received:
    0
    4 times in a row I have had the hot end dig into the bed during self leveling either in the center back or right back. I have re-greased the z axis screw, tried doing a restart and tried shutting it down, turning it off, and turning it back on. After the first time, I did the calibration wizard and the z-offset wizard.

    When the probe digs into the bed it tells me that it is offline and that I have a probing error.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    I have no clue other than a dirty sensor. I have never used the leveling feature of the R2. I manually leveled, installed newer version of Marlin and use UBL so I never level the bed just home it.
     
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Thats my first thought as well. Also ensure the bed is very clean
     

Share This Page