1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer rods bent???

Discussion in 'Troubleshooting' started by felipe fomez, Mar 28, 2019.

  1. felipe fomez

    felipe fomez Member

    Joined:
    May 19, 2015
    Messages:
    42
    Likes Received:
    0
    ive been having problems, I think my rods for the bed are bent. I level the bed and every time I print the lower part of the bed the print is good but as soon as it goes from mid to the higher part of the bed the nozzle is way higher than the lower portion. is there something im missing? if not where can I purchased the rods to be replaced. thank you
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Post a picture so we can see exactly what you mean.
     
    Geof likes this.
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Ditto. It sounds like you need to manually shim the front of your bed (between the magnets or under the bearings) to be even with the rear of the bed so your autolevel works better, BUT I cant be sure of that until we see what you mean
     

Share This Page