1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Help with setting up Octolapse

Discussion in 'General Questions' started by Carlos144Green, Mar 19, 2019.

  1. Carlos144Green

    Joined:
    Mar 19, 2019
    Messages:
    45
    Likes Received:
    6
    Hi, I am fairly experienced with 3d printing but I have never ventured into the Octoprint area of 3d printing. I recently found out that the software to run the printer using the hotspot was Octoprint. So what I plan to do is set up some cameras along with the Octolapse plugin to make the smooth time-lapses. I was wondering if anyone has done this before and is kind enough to be willing to guide me through this :) All advice and tips are appreciated!
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Doesn't the C2 already have a camera? The R2 does.
     
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    No, but I added it.

    I have used the timelaose a couple of times, but I did nothing special to configure it (I did not add a plugin, I used the one Robo already had installed on "RoboOS"/OctoPi)
     
    Carlos144Green likes this.
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #5 mark tomlinson, Mar 20, 2019
    Last edited: Mar 20, 2019
    Carlos144Green and Geof like this.
  6. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    Once the camera is installed / cabled into the RPi, you will have to log into OctoPrint and manually start / stop the video streaming. The OctoPrint home page has a menu for setting up the time-lapse parameters. That menu gets disabled while you are streaming video.
     
    Carlos144Green likes this.

Share This Page