1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

CommunitOS at work

Discussion in 'Show and Tell' started by tkoco, May 9, 2019.

  1. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    Here is the first print accomplished with CommunityOS.

    Completed-print.jpg

    What is it? A platform to hold a power supply.

    power-supply.jpg

    side-view-power-supply.jpg

    The 5 Volt supply within the C2 printer is below 5 Volts. This assembly will be used to power the RPi within the C2, however, I needed an electrically isolated means of supporting the electronics. :)
     
    #1 tkoco, May 9, 2019
    mark tomlinson likes this.

Share This Page