1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Thermosistor issue

Discussion in 'Troubleshooting' started by luckykismat86, Jun 26, 2019.

  1. luckykismat86

    luckykismat86 New Member

    Joined:
    Jun 17, 2018
    Messages:
    2
    Likes Received:
    0
    So I upgraded to a e3d v6 a while back it seems a print caught a wire and broke a wire. Replaced thermasitor and now it says 145c even when cold with no change as it heats up. Wireing is good I have no idea what the issue could be. Any ideas?
     
    #1 luckykismat86, Jun 26, 2019
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Possibly shorted somewhere, or maybe the retaining screw is too tight, try another thermistor.
     
    #2 WheresWaldo, Jun 26, 2019
  3. luckykismat86

    luckykismat86 New Member

    Joined:
    Jun 17, 2018
    Messages:
    2
    Likes Received:
    0
    Got it figured out had a cable tried it and that worked glued the cable went bad.
     
    #3 luckykismat86, Jun 26, 2019

Share This Page