1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer Ughhhh I am back... MC not printing support strucures

Discussion in 'Troubleshooting' started by robert albrecht, Aug 21, 2019.

  1. robert albrecht

    robert albrecht Member

    Joined:
    Dec 24, 2018
    Messages:
    103
    Likes Received:
    16
    I have noticed something weird. When ever I have have to print something with support structures. They do not not get printed. I check the setting and I can see that it is x. I uncheck it and re check it. I generate the view. But it is still being generated without the support structures. I am hoping this is a easy fix... Any thoughts?
     
    #1 robert albrecht, Aug 21, 2019
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Not a mattercontroller myself. Only suggestion I can offer is to try amother slicer... good luck
     
    #2 mark tomlinson, Aug 22, 2019
  3. BrooklynBay

    BrooklynBay Active Member

    Joined:
    Apr 7, 2018
    Messages:
    452
    Likes Received:
    50
    Which version are you using? Go to General then select Support Material. Is this the box with the X? Are you using Matter Slice, Cura or Slic3r as the slicing engine? Does your object have a flat bottom or are there areas which need support? Are you trying to create a raft for an object with a flat bottom? There's another setting for that.
     
    #3 BrooklynBay, Aug 22, 2019

Share This Page