1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Bed not heating

Discussion in 'Troubleshooting' started by Alvin Jacob, Sep 14, 2019.

  1. Alvin Jacob

    Alvin Jacob New Member

    Joined:
    Sep 12, 2019
    Messages:
    13
    Likes Received:
    3
    Hi,

    On giving the command to increase the temperature of the bed, the whole system restarts itself.

    Please help!!
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Sounds like your either min temp or max temping. Are there any errors on your screen or in your log on the interface ?
     
    #3 Geof, Sep 16, 2019
    Last edited: Sep 16, 2019
  4. Alvin Jacob

    Alvin Jacob New Member

    Joined:
    Sep 12, 2019
    Messages:
    13
    Likes Received:
    3
    I had resolved the problem. Some malfunctioning in the PCB board. Had to replace it.
    No errors were shown since the whole system restarts.
    But such kind of malfunction should be shown on the screen.

    Thanks
     
  5. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    When mine reboots it shows the error briefly then reboots to try to correct the issue and prevent damage. Yours did not so this ?
     
  6. Alvin Jacob

    Alvin Jacob New Member

    Joined:
    Sep 12, 2019
    Messages:
    13
    Likes Received:
    3
    No, it just switches itself off. A diode got burnt which was for the bed. I had to unplug each wire and try to find out the origination of the problem.
     
    Geof likes this.
  7. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Interesting, which part specifically did you replace and can you add a photo ? First I’ve Heard of that issue
     
  8. teachingalex123

    teachingalex123 New Member

    Joined:
    Jun 16, 2019
    Messages:
    3
    Likes Received:
    2
    I'm having a similar issue. Can you tell me where you found the problem? Thank you.
     
  9. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Probably replaced the control board (as a guess).
     
    Geof likes this.
  10. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Sounds like it. The E3 has a 2 year warranty if I recall correctly, contact Robo for a replacement main board
     

Share This Page