1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved R1 plus stepper motor wire color diagram

Discussion in 'Troubleshooting' started by Larrydoodoo, Oct 9, 2019.

  1. Larrydoodoo

    Larrydoodoo New Member

    Joined:
    May 23, 2018
    Messages:
    18
    Likes Received:
    2
    Anyone have a wire color diagram for the stepper motors for the R1 plus? Thanks in advance.
     
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    [​IMG]

    If the motor runs backwards after connection reverse either the inside pair or outside pair but NOT both.
     
    mark tomlinson and Larrydoodoo like this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Actually the stock ones if it runs backwards I usually just swap the entire connector 180 degrees :)
     
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    This works if the connector is not KEYED (small raised section on one side of the connector that goes into a cut away slot in the socket).
     
    mark tomlinson likes this.
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    You can swap it on the RAMPS board too :) Nothing keyed there.
     
    Geof and WheresWaldo like this.

Share This Page