1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Calibration cube - the untamed

Discussion in 'General Questions' started by tiagomaricate, Aug 10, 2020.

  1. tiagomaricate

    tiagomaricate Member

    Joined:
    Jul 5, 2020
    Messages:
    102
    Likes Received:
    19
    Duuuuude...

    Looks like doesn't matter what settings I use, the X always print messed this way.

    I already used jerk 0, speedy 30, reduced, and increased nozzle temperature. Everything from the cube changes. Except for these parts from X.

    Any tips?

    [​IMG]
     
  2. tiagomaricate

    tiagomaricate Member

    Joined:
    Jul 5, 2020
    Messages:
    102
    Likes Received:
    19
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Well, review this:

    Visual troubleshooting:
    ----------------------
    https://www.simplify3d.com/support/print-quality-troubleshooting/
    and :
    http://reprap.org/wiki/Print_Troubleshooting_Pictorial_Guide
    and :
    http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide

    I'd still be leaning towards speed or acceleration. It may be a loose bearing or gantry moving just a bit and if so slowing down print speed and acceleration will have a positive effect (but you should still fix the actual problem).

    Don't set any of the physics controls to 0 ... (velocity/speed, acceleration, jerk) low numbers are fine -- but not zero. Also you need to make sure if you change those that it is reflected in the Flash EPROM so check the values there.
     
  4. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    Also, @tiagomaricate , have you lubricated the rods and bearings so that the movements are unimpeded?
     
  5. tiagomaricate

    tiagomaricate Member

    Joined:
    Jul 5, 2020
    Messages:
    102
    Likes Received:
    19
    Yes I did with all axis. Much better now. Almost there...
     
    tkoco and mark tomlinson like this.

Share This Page