1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Replacement end for y-axis belt

Discussion in 'Troubleshooting' started by Bill, Jul 26, 2020.

  1. Bill

    Bill New Member

    Joined:
    Dec 20, 2014
    Messages:
    12
    Likes Received:
    4
    Does anyone know where to find a replacement end for the y-axis belt on my Robo R1 3D printer?
     

    Attached Files:

  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    You have to print one.
    Part of the new owner indoctrination -- print all printable parts :)
    If you can't -- then PM me*, I can probably mail you one. THEN PRINT MORE ;)

    When I only had one printer I had spares of everything printed. Now I just have the STLs :)




    *like with your mailing address
     
  3. Bill

    Bill New Member

    Joined:
    Dec 20, 2014
    Messages:
    12
    Likes Received:
    4
     
  4. Bill

    Bill New Member

    Joined:
    Dec 20, 2014
    Messages:
    12
    Likes Received:
    4
    Thanks Mark. I glued the broken end together. Do you have an STL file of the part that you could end to me?
     
    mark tomlinson likes this.
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
  6. Bill

    Bill New Member

    Joined:
    Dec 20, 2014
    Messages:
    12
    Likes Received:
    4
    Thanks again Mark. I downloaded the file and now have spares!
     
    mark tomlinson likes this.
  7. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    There are a lot of parts for the R1/R1+ that are on Thingiverse and if you want you can print spares for quite a bit.
    I had a medium sized box full of them before I got a second printer :)
     

Share This Page