1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

What connectors do the stepper motors use?

Discussion in 'Mods and Upgrades' started by K Tran, Jun 29, 2021.

  1. K Tran

    K Tran New Member

    Joined:
    Oct 8, 2020
    Messages:
    3
    Likes Received:
    0
    I got JST-XHP connectors but it’s slightly too big for the motors.


    Sent from my iPhone using Tapatalk
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    On the R1?
    Do you mean the end of the wires that connect to the stepper or the other end where it connects to the RAMPS?
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
  4. K Tran

    K Tran New Member

    Joined:
    Oct 8, 2020
    Messages:
    3
    Likes Received:
    0
    [mention]mark tomlinson [/mention] Thanks! I needed the plug that fits into the stepper motor so I’ll order these


    Sent from my iPhone using Tapatalk
     
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Good luck, the one that plugs into the stepper (not the end that plugs into the RAMPS) is the one you need (JST-XH2) I think -- but those have both ends.
     

Share This Page