1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered First layer

Discussion in 'Troubleshooting' started by JWW, Nov 8, 2021.

  1. JWW

    JWW Member

    Joined:
    Dec 10, 2015
    Messages:
    200
    Likes Received:
    18
    Thanks, I'll give it a shot on the next print. BTW, I did go to the Simpilify3D forum and did a few searching but it didn't come up with anything. Then again the search criteria to use was had to figure out.
     
    mark tomlinson likes this.
  2. JWW

    JWW Member

    Joined:
    Dec 10, 2015
    Messages:
    200
    Likes Received:
    18
    I wasn't looking for anything special, just PLA that prints well on a Robo R1 plus.
     
  3. JWW

    JWW Member

    Joined:
    Dec 10, 2015
    Messages:
    200
    Likes Received:
    18
    I designed a fixture so to speak for a Leica Bullet Stage to adapt to my Nikon MM-11 toolmakers microscope baseplate. The Bullet Stange has adjustable X/Y/Z movement along with a rotating top stage. The printer did a great job. Thanks for all the help Mark.
     

    Attached Files:

    mark tomlinson likes this.

Share This Page