1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Not printing after bed leveling

Discussion in 'Troubleshooting' started by Johndrindak, Feb 21, 2016.

  1. Johndrindak

    Johndrindak New Member

    Joined:
    Feb 20, 2016
    Messages:
    12
    Likes Received:
    0
    after the leveling it stays on the last spot
     
  2. Shigemal

    Shigemal Member

    Joined:
    Aug 19, 2013
    Messages:
    126
    Likes Received:
    13
    You should look mlnitor of logs from mattercontrol.

    Tapatalk を使用して私の SO-02G から送信
     
    mark tomlinson likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    I agree, that is normally where mine would throw the TEMP FALL error.
    See if you have a TEMPERATURE FELL TOO MUCH sort of error in the console log.
     
  4. Shigemal

    Shigemal Member

    Joined:
    Aug 19, 2013
    Messages:
    126
    Likes Received:
    13
    I had faced similar issue as you seen, but root causes are varied on your situation.
    So please take look console log first.
    on my case frequently happened after many ABS printing, so it means heavy current load has applied on RAMPS shield.
    It may cause failure on ATMEGA and RAMPS shield.
    Finally I had recognized connector failure of RAMPS shield power.
    I had replaced hot-end with E3D volcano, after this change I had enjoyed smooth printing but it cause failure of this issue.
    You can see it in following picture.
    Now I have replaced RAMPS shield and also order spare parts of this header plug.
    And also I have added 4cm cooling fan for this area.
    Please take look your HW with setting. loose connection of this plug makes failure as my case.
    But it is my case, you may have another story , so please share your case with console log and also digging your hardware with picture.

    regards
    Shigemal IMG_5666.JPG IMG_5667.JPG IMG_5668.JPG IMG_5669.JPG
    IMG_5666.JPG IMG_5667.JPG
     

Share This Page