1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered Bed Overheat error

Discussion in 'Troubleshooting' started by richpants, Feb 24, 2016.

  1. richpants

    richpants New Member

    Joined:
    Mar 22, 2015
    Messages:
    2
    Likes Received:
    0
    The last 3 times I have gone to print I get an error after the Robo stops stating the Bed temp, has gone to high. I don't know if this is a software or a hardware problem. Rather I do not know where to begin my troubleshooting.
    thanks.
     
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    What temperature are you trying to get to?
     

Share This Page