PLA BRASS

Im not sure if its pla but the brass infill i got a sample pack from printed solid what are peoples thoughts? What did they run it at? I have the newest robo with its origanl extruder still how does that hold up?

 

I have been printing with the bronze fill.
I love it, I have printed up a storm with it (1 full 1.5kg roll).

195C, 15mm/s first few layers then 30mm/s there after.
Using Simplify3d due to the insane amount of supports I need.

However, I use a stainless steel nozzle in 0.40 on a volcano. So it is not quite a fair apples to apples comparison. The volcano has a larger heat zone, so I can run at much lower temperatures and thus do not over cook the material.

 

Yea i wanna be very careful so ill probably wait till i get my e3d v6 hotend on.

 

Make sure to hit up @Printed Solid for a hardened nozzle:
https://printedsolid.com/collection...products/e3dhardenednozzle?variant=7434731715

 

yea i was going to get one before i printed with this