1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

XXL LCD Mounting Screws

Discussion in 'General Questions' started by MChrisP1, Mar 22, 2016.

  1. MChrisP1

    MChrisP1 Member

    Joined:
    Mar 5, 2016
    Messages:
    39
    Likes Received:
    12
    OK all, I have my case printed up for my XXL LCD, and it turned out great. I have a pretty easy question though before I mount the LCD... Is there any type pf special screw I should be using to mount the LCD/Board to the case? Looks like some M3s i have from my RC car parts pile will fit it but do I need to worry about insulated screws or anything like that? I don't think I do, but would like all of your expert opinions before i accidentally fry any electronics.

    Thanks as always!

    Chris
     
  2. KTMDirtFace

    KTMDirtFace Well-Known Member

    Joined:
    May 18, 2015
    Messages:
    1,247
    Likes Received:
    461
    If I recall I needed some M2's and M3's and nuts. no you wont fry anything.

    I think the thingiverse link says exactly what screws to use...depending one what case you printed.
     
  3. MChrisP1

    MChrisP1 Member

    Joined:
    Mar 5, 2016
    Messages:
    39
    Likes Received:
    12
    I went through a whole bunch of different links on thingiverse trying to find the one with instructions, but could not find it anywhere.

    Thanks for the tip!


    Sent from my iPhone using Tapatalk
     

Share This Page