1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved The extruder seems obstructed

Discussion in 'Troubleshooting' started by Hugo César Tarelo, Apr 3, 2016.

  1. Hugo César Tarelo

    Hugo César Tarelo New Member

    Joined:
    Apr 3, 2016
    Messages:
    2
    Likes Received:
    1
    Printing the extruder filament not pulled, the impression was left half.
    Load the filament once again, but after inserting two inches PLA no longer runs the extruder. It is obstructed? you can do something?
     
    #1 Hugo César Tarelo, Apr 3, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, Apr 4, 2016
    Hugo César Tarelo likes this.
  3. Hugo César Tarelo

    Hugo César Tarelo New Member

    Joined:
    Apr 3, 2016
    Messages:
    2
    Likes Received:
    1
    It's great, I solved it ...
    Thank you very much.
     
    #3 Hugo César Tarelo, Apr 4, 2016
    mark tomlinson likes this.

Share This Page