1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Hardware or Software Issue

Discussion in 'Troubleshooting' started by ParamedicStan, Apr 13, 2016.

  1. ParamedicStan

    ParamedicStan Member

    Joined:
    Jul 21, 2015
    Messages:
    31
    Likes Received:
    21
    IMG_20160413_140906 (Medium).jpg

    So I was printing all three pieces at the same time and this happen.... clearly a layer shift but only on the 2nd and 3rd pieces, than corrected it self....

    Settings, PLA, 205/50 speed 50mm,

    Comments...
     
    #1 ParamedicStan, Apr 13, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Looks like belt skip, but odd that it did not affect them all.
    It almost seems like it jumped a tooth and then jumped back.

    (not improbable, but unusual)
     
    #2 mark tomlinson, Apr 13, 2016
  3. jonnyb44

    jonnyb44 Member

    Joined:
    Feb 11, 2016
    Messages:
    75
    Likes Received:
    16
    Or a lose set screw??


    Sent from my iPhone using Tapatalk
     
    #3 jonnyb44, Apr 13, 2016
    mark tomlinson likes this.
  4. ParamedicStan

    ParamedicStan Member

    Joined:
    Jul 21, 2015
    Messages:
    31
    Likes Received:
    21
    Thanks for the info...
     
    #4 ParamedicStan, Apr 14, 2016

Share This Page