1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Gaps in the outer shell

Discussion in 'Troubleshooting' started by zenekNY, Jul 3, 2016.

  1. zenekNY

    zenekNY Member

    Joined:
    Aug 29, 2015
    Messages:
    148
    Likes Received:
    17
    I am using White PLA+ form eSun which is supposed to print at 205C-225C
    Now runing it at 185C with the best results, which ist 20C under what is suggested.
    And yes, I am using oiler, I also did a taulman pulls to make sure everything is clean.
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I think when i ran the hex i used 1.6mm retraction with 60mm/sec had good results. I recall having the same issue and just needed to up my retraction (from 1) and speed from 30. Maybe do a short test print to see
     
  3. zenekNY

    zenekNY Member

    Joined:
    Aug 29, 2015
    Messages:
    148
    Likes Received:
    17
    I will try that in just a minute. Thank you for the suggestion.


    Sent from my iPhone using Tapatalk
     

Share This Page