Solved Print bed off center

Hi Everybody

Just got my New R1plus the other day and i have noticed that my print bed is not centered. When it starts to print something big it doesn't print in the outlined squire that is in the center of the print bed its a few inches behind it. what can i do to fix this ?

 

The Robo company likes to think outside of the box, so they made a box on the printed bed that illustrates their philosophy. Like mark said...meaningless. Haha

 

Also don't freak out when you find that your 10"x9" build area is being heated by an 8"x8" heat pad. So if you print ABS it might lift at the extreme edges.

 

I have had PLA large prints lift at the point they were not directly over the 8x8 heater......verified with IR Thermometer......rotating the print 45 degrees, cured the lifted corners, all other settings remaining the same.

 

Thanks for your help guys