1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Support material settings

Discussion in 'General Questions' started by Nathanfish, Nov 4, 2016.

  1. Nathanfish

    Nathanfish Active Member

    Joined:
    Aug 6, 2015
    Messages:
    306
    Likes Received:
    34
    So i've had a few prints lately that have had some decent overhang and tight tolerances. I just realized you can change the support infill angles and criss cross the infill. I haven't had a chance to test it out but does anyone have settings they would like to share? I searched but couldn't find much other than percentages other people have used.

    Thanks
     
    #1 Nathanfish, Nov 4, 2016
  2. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    Which software are you using? Matter Control, Cura, Simplify 3D?
     
    #2 danzca6, Nov 4, 2016
  3. Nathanfish

    Nathanfish Active Member

    Joined:
    Aug 6, 2015
    Messages:
    306
    Likes Received:
    34
    Should have specified that. Using Simplify
     
    #3 Nathanfish, Nov 4, 2016
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #4 mark tomlinson, Nov 4, 2016

Share This Page