1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved calibrating print quality.

Discussion in 'Troubleshooting' started by TKCC71, Nov 15, 2016.

  1. TKCC71

    TKCC71 Member

    Joined:
    Mar 24, 2016
    Messages:
    75
    Likes Received:
    31
    I think I might of solved the issue. I had the cables routed to the wrong side of the threaded Z rods. As the extruder was going up the cable was probably getting snagged on one of the motors on the right side as it went higher. Thats probably why the lower print was coming out great. I'm printing the part again and will see how it comes out. I also printed a belt tension clip as well. Will see how it turns out in a few hours.

    [​IMG]

    http://www.thingiverse.com/thing:10034
    re's a quick video of my belt.
     
  2. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    Oh yeah...that could do it alright. Fingers crossed that was all it was.
     
  3. Chuck Erwin

    Chuck Erwin Active Member

    Joined:
    Aug 27, 2015
    Messages:
    202
    Likes Received:
    136
    I hope you got it.
     

Share This Page