Solved Straiating Pattern on Front and Backs of Prints?

I noticed this starting to happen today, it seems much more pronounced on the front and back of the prints, but it can be seen on every side.

Pics
https://imgur.com/a/beXwv

Specs
Material - PLA
Extrusion Temp - 210 C
Bed Temp - 60 C
Bed makeup - Borosilicate Glass with no Adhesion Agent

 

That's looking like the infill showing through. Couple more settings needed. What speed? What infill percentage? How many shells? Shells might be it. I normally for me around 3 shells so that the walls are thick enough not to show the infill.

 

Speed - 100 mm/s
20% Fill Density
Can't seem to find the shell setting in Cura, but the thickness is .8 mm.

 

R1+

 

Are you using the Cura 15.04 settings I posted in reply to your question a couple of days ago?
http://community.robo3d.com/index.php?threads/cura-2-r1-setup.17126/

 

Yeah, the ones from Fat Dragon.

 

I recommend trying the Cura settings I posted at the bottom of that thread.
http://community.robo3d.com/index.php?threads/cura-2-r1-setup.17126/

As danzca6 recommended above, you can try 3 shells. The thickness in Cura should be a multiple of your 0.4mm nozzle. So to get three shells, use 1.2 shell thickness.

 

That might be a tad fast...try cutting that in half. Change the shells to 1.2 so then you have 3.

 

Halved the speed, and set the shell thickness. Will see what comes of it.

 

Just finished a test print, the striations seem to be gone! Thank you, is there any other tips you have to improve print quality?

Pics - http://imgur.com/PULzdEK

 

That does look a lot better. Here is a good visualization thread to help with knowing what settings or calibrations you can do in order to fix common print quality issues. http://community.robo3d.com/index.php?threads/visual-troubleshooting-guide.3017/