1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

add support for builds

Discussion in 'General Questions' started by Joshedmondson87, Dec 18, 2016.

  1. Joshedmondson87

    Joshedmondson87 New Member

    Joined:
    Dec 16, 2016
    Messages:
    8
    Likes Received:
    0
    in currently using matercontrol right now. how do I go about adding support to my model before printing.
     
  2. Chuck Erwin

    Chuck Erwin Active Member

    Joined:
    Aug 27, 2015
    Messages:
    202
    Likes Received:
    136
    Here you go: Warning I am using the alpha version for testing but it should be close enough.
    supports.PNG supports.PNG
     
  3. Joshedmondson87

    Joshedmondson87 New Member

    Joined:
    Dec 16, 2016
    Messages:
    8
    Likes Received:
    0
    Yes that is checked. Im trying to build a hulk figure but it wont build supports to his fingers so his hands can build. Is there a editor where i can add supports or rods myself.
     
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I don't believe any of the free slicers have this option
     
    mark tomlinson likes this.
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Correct. Something like MeshMixer will let you do that, but no clue on how good they end up being.
     
    Geof likes this.
  6. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Meshmixer support was pretty good as far as I can remember, but it has been at least 7 or 8 months since I looked at it so I don't even remember on what or why I was using it.

    http://www.meshmixer.com/
     
    Geof likes this.
  7. Chuck Erwin

    Chuck Erwin Active Member

    Joined:
    Aug 27, 2015
    Messages:
    202
    Likes Received:
    136
    I haven't used my Robo3d R1 in awhile truth be told but I or anyone willing can slice the model for you using S3d. That might work for you if you are only having trouble with this model.

    Also make sure you run the model through https://tools3d.azurewebsites.net/ then see if the supports show up.
     
  8. Rigmarol

    Rigmarol Well-Known Member

    Joined:
    May 14, 2016
    Messages:
    544
    Likes Received:
    280
    Check if the box "Support Everywhere" is ticked.
    Otherwise it will only put in support if it goes down to the bed. The hands may possibly be over another part of the model.
    Something to check.
     
    Geof and Chuck Erwin like this.

Share This Page