1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. adikted2astro
    Thread

    New PEI sheet and auto bed-leveling...WTF

    So I was able to get the PEI off my print bed, but I ran into a problem. After I removed the PEI, I wanted to see if I could print some ABS on...
    Thread by: adikted2astro, Oct 16, 2017, 11 replies, in forum: General Questions
  2. adikted2astro
    Thread

    Freezing Heated Bed

    So I need to replace my PEI sheet and I've read some stuff on how to do it, including the link for Prusa's method. Can the R2 bed be placed in a...
    Thread by: adikted2astro, Oct 13, 2017, 1 replies, in forum: General Questions
  3. adikted2astro
    Thread

    JST Connectors?

    Hi all, I want to replace my hexagon hotend, but I don't know which JST connectors to get. There is a C2 thread about dual extruders, but it only...
    Thread by: adikted2astro, Oct 9, 2017, 4 replies, in forum: General Questions
  4. adikted2astro
    Thread

    Upgrading Extruder on R2

    Sorry for all the questions, but I'm extremely interested in upgrading some components on my R2. My current hotend is doing just fine. I haven't...
    Thread by: adikted2astro, Sep 6, 2017, 26 replies, in forum: General Questions
  5. adikted2astro
    Thread

    Bushings for X and Y axis rods

    Hey, does anyone know what size the bushings are for the x and y axis rods? I know the rods are 6 mm in diameter, but unless I tear the carriage...
    Thread by: adikted2astro, Sep 6, 2017, 17 replies, in forum: General Questions
  6. adikted2astro
    Thread

    Problem with Permanent PID Settings

    So I've been having this problem for a while, but I haven't addressed it yet because I was concerned about a far worse problem involving my z-axis...
    Thread by: adikted2astro, Sep 4, 2017, 10 replies, in forum: Troubleshooting
  7. adikted2astro
    Thread

    Horizontal Ridges in ALL of My Parts

    I've done a couple of dozens different prints and every single one of them have these "ridges" on flat surfaces. They oscillate like a sine wave...
    Thread by: adikted2astro, Aug 22, 2017, 23 replies, in forum: Troubleshooting
  8. adikted2astro
    Thread

    PEI Print Bed Problem

    This may not actually be much of a problem. I guess I just need some advice. I received my R2 today and set everything up. It printed a perfect...
    Thread by: adikted2astro, Aug 10, 2017, 19 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 28 of 28
Search Again
Page 2 of 2