1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Mutalist
    Post

    Z Offset issue, Extruder head & Bed collide.

    Which ones should I try first? I used Cura, and Qidi so far, since I have a Qidi printer, but it wont work well with robo either.
    Post by: Mutalist, Jul 5, 2019 in forum: Troubleshooting
  2. Mutalist
    Post

    Z Offset issue, Extruder head & Bed collide.

    How well does it work with them?
    Post by: Mutalist, Jul 5, 2019 in forum: Troubleshooting
  3. Mutalist
    Post

    Z Offset issue, Extruder head & Bed collide.

    Which software do you use?
    Post by: Mutalist, Jul 5, 2019 in forum: Troubleshooting
  4. Mutalist
    Post

    Z Offset issue, Extruder head & Bed collide.

    Hey Mark, it's been a few days, and the printer is going good. Thank you again for the help on fixing my issue going with the printer. Do you know...
    Post by: Mutalist, Jul 5, 2019 in forum: Troubleshooting
  5. Mutalist
    Post

    Z Offset issue, Extruder head & Bed collide.

    So, after doing so, it didn't collide with the plate at all, it went over to the front left side, and actually tried printing, the filament was a...
    Post by: Mutalist, Jul 3, 2019 in forum: Troubleshooting
  6. Mutalist
    Post

    Z Offset issue, Extruder head & Bed collide.

    I went ahead and did what you told me, and when I went in to go and look at it, it was calibrated with the exact numbers when I redid the z...
    Post by: Mutalist, Jul 3, 2019 in forum: Troubleshooting
  7. Mutalist
    Thread

    Z Offset issue, Extruder head & Bed collide.

    I'm new to using a Robo R2 printer, I've never used a Robo printer before, and I have access to one I'm trying to get setup. My two biggest...
    Thread by: Mutalist, Jul 3, 2019, 16 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again