Separate names with a comma.
Thanks @WheresWaldo, I'll give those a try!
I'm looking to replace the lead screw nut for the Z-axis stepper and not sure what the correct lead screw pitch and lead the R2 uses, does anyone...
Yikes! I dont think I have had the need to print anything that large with it yet and I mostly print on Garolite, I have used the purple glue...
I print with NylonX a lot on my R2, probably 5-6 rolls through it now and it prints beautifully! My R2 is modified with an E3D V6 and Titan...
The pins for the V2 Bed harness connector: AMP TE 1-104479-3 (you will need a crimping tool to install them or you could solder them).
I havent printed any straight nylon yet it's all been of the CF variety and the CF in it does stiffen it up to help prevent warping, It warps much...
I have been printing successfully with the PC CF filament (I believe it's Priline brand) using straight PEI sheet, this stuff likes to be squished...
just use one of these, should only take a second or two.
Of course, thats exactly how I was able to make the changes easily, it's only fair that I share what was intended to be shared to begin with!
Here is the link to the solid file: https://a360.co/2JVvhQo
.STL is attached for slice and print.
Sure I'll upload them tomorrow when I get back in town.
Anyone see this? Looks like a really nice solution.
Robo R2 X/Y carriage E3dv6 Mod
Anyone find a source for these? I cant seem to find any that are 40mm, just 35mm.
Ok I'll give that a try...
Ok so it the power + from fan 1 to be used as the signal wire?
This is what Im trying to connect, main power is coming from the 24v board connection like in Waldo's first post.
Not really, unless Im looking at this wrong. Does the fan 1 connection on the board replace this connection in the original post?
Can you explain this with a bit more detail?
I got remove fan2 (stock lights) and plug the main board fan (now in fan 1) into the fan2 position,...
Here is the shroud, still tweaking it a bit though. Printed with NylonX