Separate names with a comma.
Thank you for your very thorough reply. I really like my R1. I just put an E3D V6 hot end on it. May I ask you for some tips on what works for you...
Hello, I own an R1+ and I have been considering to switch to an R2.
Are there any advantages on this?
My R1 was recently upgraded to an E3D V6....
Mark, thank you for your reply.
When you say minor changes for the E3D. What you mean? Can you advise me on those particular changes. I would...
What version, would you recommend? If not stock. I just installed the E3D v6.
I read that marking has had many improvements. I would like to...
Hello, I would like to know what is the current Marlin/firmware revision for the R1 Plus. And how to get it.
This is the end Gcode.
G92 Z0 ;set current z position to be new 0
G91 ;relative positioning
G1 E-1 F300 ;retract the filament a bit...
I am having the same problem. But with S3D works fine. I really need Cura to work on my Robo because the detailed profile I don’t get in simplify....
Thank you for the replies.
This is the starting script
G28 ; home all axes
G29 ; probe the bed
G1 Z5 F5000 ; lift nozzle
Hello. I am printing PLA and my first layer looks like this picture. Using Simplify. Can you please help me solve this?