Separate names with a comma.
Ok still a little confused but I was able to use the gcode and it changed the firmware so that is good. Thank you!
Do you have to use the EEPROM? And if so when would I have enabled it and how?
So I had edited the firmware but it didn't require me to use the M502 and the M500 gcode commands
In pronterface I don't think you need the semicolons, just to let you know.
Also, when I added my lcd screen I didn't have to mess with anything in the gcode, why is that?
Ok so I'm really not an expert with gcode but you kinda lost me in the first post and talking about EPROM and what that is.
So I was calibrating my new E3D V6 hotend following this video,
by Tom and I changed the value in the arduino code for the printer to...
I think I got is somewhat working but if I have questions, I'll post here.
I should have mentioned this before but I am actually using abs.
I can extrude filament from it already, I checked that when I was hot tightening the hot end, I'm just not sure why it doesn't extrude...
It's has nothing to do with the hot end or the filament itself I don't think, its just not gripping the filament. Should i cut the ptfe tubing...
You could also put it on the z axis stabilizers, but definitely put it on the z axis where the threads are.
I have already tried that, but it doesn't seem to grip the filament any better.
So I just got around to installing my E3D hotend, I drilled out the extruder hole for the ptfe tubing and everything is fine, the only problem is,...
Can you make an updated version of this for the newest cura version and make sure to add the end gcode also. Thanks!
oh also if I have the firmware for the lcd on but i want to use cura, do i have to change firmware or will it work still.
wait how do i change this to resolved.
wait nvm i homed all the axis and it worked, thanks for al the help, if i need more i will reopen this.
ok so I think it is now working but on the lcd you can't move the axis's back and forth right it only goes one direction right, because if my...
Wait so I download the R1+ file from here https://help.robo3d.com/hc/en-us/articles/115000717071-Updating-firmware-with-Arduino and uploaded it...