1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. usafitz
    Thread

    Bed pin problem

    I just got a disconnect error during a print. When I lifted the bed, this is what I found: [IMG] It looks like the spring action in the left...
    Thread by: usafitz, Mar 14, 2018, 7 replies, in forum: Troubleshooting
  2. usafitz
    Thread

    Ever print like this?

    Wow... I woke up to this. No clue how it happened... I assume the hot end came loose first and then the prints messed up. Anyone ever seen this...
    Thread by: usafitz, Aug 1, 2017, 4 replies, in forum: Troubleshooting
  3. usafitz
    Thread

    Screen Blank - no Octiprint

    This was disappointing.... I with the exception of a little circle that I made to test things, I haven't gotten a good print out of my R2. This...
    Thread by: usafitz, Jul 30, 2017, 12 replies, in forum: Troubleshooting
  4. usafitz
    Thread

    Z Offset - print 1 CM from bed

    I ran the z offset wizard and got -9.2 as the result. Then, I went on to step 5 in the instructions to do a test print, but the space between the...
    Thread by: usafitz, Jul 1, 2017, 4 replies, in forum: Troubleshooting
  5. usafitz
    Thread

    Solved Y-axis Auto Level Problem

    Hey all, thanks in advance for your thoughts. One of my printers is an R1 with rod upgrades. The bed holder was worn out, so I replaced the...
    Thread by: usafitz, Apr 29, 2017, 5 replies, in forum: Troubleshooting
  6. usafitz
    Thread

    Epic bad print!

    Just wanted to share... solid ball of plastic (PLA). It was about an hour print... lesson learned, always check on your prints :) [IMG]
    Thread by: usafitz, Apr 2, 2017, 13 replies, in forum: Show and Tell
Showing results 1 to 6 of 6
Search Again