Separate names with a comma.
Thanks, but that did not work either. Just giving up on a reverse screen. I flipped it in the regular view, I lost just a hair from the top of the...
I am still at a standstill with the screen looking as it should but the touch is flipped. Any help please?
Ok, I have that part fixed. I tried to run the commands all together instead of individually.. Now my problem is while the screen looks great and...
Of the below commands, are all done at one time or do I do one at a time?
I did press Y and then enter and the next line shows abort, and then command line
Ok, I made the plunge to upgrade my screen and all was going great until I ran the final updates. Did I run out of space? What do I need to do?...
As of Aug, I would have my R2 for 1 yr and I have the 2yr warranty plan, and I have a warranty item (Hotbed cable) but they are not responding to...
Is the R2 and C2 the same except for the heater core? If so couldn't just switching the heater core make it the r2 hotend?
Have you all heard or know about this company Partsbuilt 3D?
I have heard some rumors that Robo was not doing good and was likely going out.. I hope this is not the case..
I will take a look… thx
mark, sure I will give it a try... Is there a video or something to show me how to change the connectors?
Robo is out of the hotend/extruder for the R2, does anyone know where I can get the exact replacement?
Do you think this renaming procedure will work with a R2 image?
Does any one know what's up with Robo3D? I mean their shop is out of a lot of items for a while now and no one is responding to emails or...
I need to replace the senor for the filament run out and the sensor for the bed leveling etc.?
Any one know what the R2 uses?
Completed it, but it still is coming up. Besides the gcode, does cura put any kind of files on the SD? When I reloaded Cura, all my settings and...
I get the following error every time I start Cura for my R2:
"error an exception occurred while parsing the json file"
I have had 2 heat bed cables go bad on me. The first cable had melted wires just before the base connector. It exposed opened wires on three of...
Does any know how one would connect to the R2 RPI? Trying to connect Mosaic Canvas via OctoPrint and I can not seem to figure it out