1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Schlomo
    Post

    R1+ Auto-Level not really accurate

    Is there something you would suggest that could help? Custom G code? Modification to my Firmware? The shim i put in was about .3mm on the right...
    Post by: Schlomo, Feb 2, 2016 in forum: General Questions
  2. Schlomo
    Thread

    R1+ Auto-Level not really accurate

    I've been successfully printing for a while now with my R1+, but have been having issues with my first layer adhesion in some cases due to the...
    Thread by: Schlomo, Feb 2, 2016, 21 replies, in forum: General Questions
  3. Schlomo
    Post

    PEI Print Bed

    Thanks for the suggestion. I'll try a roll. It seems my printer is not quite level even after the auto level. I'm going to try to shim up my bed...
    Post by: Schlomo, Feb 1, 2016 in forum: Mods and Upgrades
  4. Schlomo
    Post

    PEI Print Bed

    [IMG][IMG] Both of these were printed before the pei sheet was added. Heated chamber at 50c, 100c bed temp. Hair spray on bed. The failed one...
    Post by: Schlomo, Feb 1, 2016 in forum: Mods and Upgrades
  5. Schlomo
    Post

    PEI Print Bed

    The only thing i did was apply the abs tape, and stick it to the bed after trimming, and remove the top plastic protector. I did not wipe down...
    Post by: Schlomo, Feb 1, 2016 in forum: Mods and Upgrades
  6. Schlomo
    Post

    PEI Print Bed

    Hatchbox Sent from my Transformer Prime TF201 using Tapatalk
    Post by: Schlomo, Feb 1, 2016 in forum: Mods and Upgrades
  7. Schlomo
    Post

    PEI Print Bed

    I just did this upgrade and went from having almost 0 issues with corners lifting to having all of my prints have raised corners... im not...
    Post by: Schlomo, Feb 1, 2016 in forum: Mods and Upgrades
Find older messages
Showing results 21 to 27 of 27
Search Again
Page 2 of 2