Separate names with a comma.
I will have to get back to you later I have to go do some stuff
to my knowledge I didn't change the home direction. I will apply those changes and get back to you. thanks for your help
so I need to change the hardware for the printer to function properly? I only changed the firmware and that made it home properly
sorry about being vague let me try to clear that up basically when I home the printer both the x and y axis home away from their respective home...
when I home the axes it takes the extruders to the back right when it should be taking the extruders to the front left how would I fix that?
so this is what I am getting out of pronterface (this is without any of the home switches being touched by a part of the printer)
I think that I also have my x and y home switches switched
thats what I figured I would have to do
when I home it the bed moves in the wrong direction away from the home switch and runs to the end and grinds the motor how would I change the...
ok so it seems that z works fine but when I go to control x and y it will go in the positive direction but not the negative direction what might...
does it matter where positive and negative leads are on the outside prongs
my settings in the firmware match that is it possible that the problem could be elsewhere? Is it possible the problem is that the end switch is...
ok so I would probably need to invert the setting for them in the firmware to make them only trigger when hit?
are the home switches the limit switches for the axes?
why would I only be able to move the stepper motors on the x y and z axis in the positive direction?
I guess I may be a little special then. how many times do you have to try to calibrate for esteps usually?
I have tried using the ratio for esteps and it doesn't seem like the equation works
I reloaded the EEPROM a few times and the same results it seems that something isnt working right because the esteps for both extruders appears...
it seems like both extruders are using the same esteps do you have any idea why that would be happening?
my esteps for both extruders are: 150 and 1916 is it ok that the numbers are that different?