1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Caio Mallagoli
    Post

    Solved Manual Bed Leveling

    Thank you! i will print and try, and also give you a feedback!
    Post by: Caio Mallagoli, Jun 14, 2019 in forum: Troubleshooting
  2. Caio Mallagoli
    Post

    Solved Manual Bed Leveling

    See the attached pictures. whrere is the bolts?
    Post by: Caio Mallagoli, Jun 13, 2019 in forum: Troubleshooting
  3. Caio Mallagoli
    Thread

    Solved Manual Bed Leveling

    Hi, my Robo 3D is the first model from kickstarter and i have a quick question, on side of my bed is higher than the other, do exist a screw to...
    Thread by: Caio Mallagoli, Jun 13, 2019, 5 replies, in forum: Troubleshooting
  4. Caio Mallagoli
    Post

    MatterControl sets temperature 260 ºC

    OK, thnak you very much, i will try to replace the thermistors. ;)
    Post by: Caio Mallagoli, May 29, 2018 in forum: Software
  5. Caio Mallagoli
    Post

    MatterControl sets temperature 260 ºC

    i attached some pictures about my printer to confirm the thermistor. [ATTACH] [ATTACH] [ATTACH] So the thermistor is a class J ?
    Post by: Caio Mallagoli, May 29, 2018 in forum: Software
  6. Caio Mallagoli
    Post

    MatterControl sets temperature 260 ºC

    Hi, i'm back, i checked all and than my thermistor is gone, do you have the technical information of the 100 Kohm thermistor ?
    Post by: Caio Mallagoli, May 29, 2018 in forum: Software
  7. Caio Mallagoli
    Post

    MatterControl sets temperature 260 ºC

    thanks! i will spend some days dealing with this, then i give you a feedback! thanks again for your time! best regards
    Post by: Caio Mallagoli, May 28, 2018 in forum: Software
  8. Caio Mallagoli
    Post

    MatterControl sets temperature 260 ºC

    There is another way to check/test the thermistor before buy a new one? What is the advantages to change for this new hotend? i am new at 3d...
    Post by: Caio Mallagoli, May 28, 2018 in forum: Software
  9. Caio Mallagoli
    Post

    MatterControl sets temperature 260 ºC

    I have the original old one, do you thing thar is better change the hotend? where can i buy theses items to fix and/or upgrade?
    Post by: Caio Mallagoli, May 27, 2018 in forum: Software
  10. Caio Mallagoli
    Post

    MatterControl sets temperature 260 ºC

    How can i try to fix or substitute this sensor? If i can't fix where can i buy a new one to replace? Thanks for the fast answer
    Post by: Caio Mallagoli, May 27, 2018 in forum: Software
  11. Caio Mallagoli
    Thread

    MatterControl sets temperature 260 ºC

    Hello! This is my first post, my printer is a R1 from the KickStarter, and the MatterControl suddenly sets the temperature 260 ºC as the...
    Thread by: Caio Mallagoli, May 27, 2018, 21 replies, in forum: Software
Showing results 1 to 11 of 11
Search Again