Separate names with a comma.
there are no Hex files? wouldn't that be easier?
where would I find marlin 1.1.9. I just did a search and this thread showed up.
I was wondering about this also.
My robo says V1
I downloaded form here it says V2...
I have a filament oiler but I always forget about it.
yes it was PLA.
what do you mean "seasoned"
can you recommend nozzles.?
how bout these...
yeah I did that and it worked.
also a couple other things:
I was thinking maybe there was a bit of a clog that caused under extrusion also????
I dont know what happened.
I never had this problem before.
just printed a test support in matter controll. worked fine.
I went to print another...
thanks to everyone here that has helped me and answered my questions.
it is a great resource.
SUCCESS! at 15 mm/s 230C
yeah, I thought that was faster than 25mm/s.
so I wasnt surprised to have a problem/
so I slowed it down to 15mm/s. and I had the same problem.
first attempt was at 25 mm/s
I thought this was going faster:
so I decided the try the bic pen method before breaking out the drill.
it was going surprising well....until... the filament backed up in the...
regarding drilling. I will be able to remove the tube to print as before without sacrificing performance?
yikes, I just unscrewed the spring tensioned bolts.
the hobbed bolt looks mighty close to the hole that need to be drilled.
people have done this...
I was going to slice in matter control.
I dont see a setting to disable retraction so I am setting all fileds to 0.
I set all speeds at 25
so is this what I need to drill larger (where tweezers are pointing)...
yes I read about this and at one point, a long time ago , I was going to try. But I lost my nerve.
some were talking about drilling. that...
will it work with the ptfe tube?
or must I replace the extruder?
I just purchased
SainSmart Purple Flexible TPU.
it has a shore hardness of 95a
after reading some of reviews
I was thinking of printing on my...
although the above g code worked on both cura 15.04.06 and 3.6.
after the auto level 3.6 wanted to go off beyond the home point.