1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 6 of 6
  1. AlienBeans
    Post

    Cracking noise

    I was able to get the rods straightened, so that is solved.
    Post by: AlienBeans, Jun 12, 2017 in forum: Troubleshooting
  2. AlienBeans
    Post

    Cracking noise

    There really isn't a top cover to remove. I tried independently adjusting one end (gently) but with the belts and all its not moving without...
    Post by: AlienBeans, Jun 11, 2017 in forum: Troubleshooting
  3. AlienBeans
    Post

    Cracking noise

    Ed. That was great information. I did exactly as you outlined above and then I noticed something. I noticed during the tests that the noise...
    Post by: AlienBeans, Jun 11, 2017 in forum: Troubleshooting
  4. AlienBeans
    Thread

    Cracking noise

    I noticed it in a small print I did earlier today, and now I'm doing a larger print and there's a cracking/clicking sound coming from the printer...
    Thread by: AlienBeans, Jun 10, 2017, 12 replies, in forum: Troubleshooting
  5. AlienBeans
    Post

    Stress testing using "Ready for Battle" Figure

    What was the print time for this? Print looks pretty good.
    Post by: AlienBeans, Jun 9, 2017 in forum: Show and Tell
  6. AlienBeans
    Post

    Cura 2.5 fails after install

    When I attempt to download Cura 2.5 for Robo from the Robo site, Avast flags it as a virus. I set it as an exception to download it, but when I...
    Post by: AlienBeans, Jun 8, 2017 in forum: General Questions
  7. AlienBeans
    Post

    Z Offset Tool

    Interesting because the setup instructions say Place INCLUDED Z OFFSET TOOL on print bed and press up and down on screen buttons while sliding the...
    Post by: AlienBeans, Jun 8, 2017 in forum: General Questions
  8. AlienBeans
    Thread

    Z Offset Tool

    What does this tool look like? I have an accessory box with 3 allen wrenches and what looks like a pair of tweezers as well as a small tube of...
    Thread by: AlienBeans, Jun 8, 2017, 3 replies, in forum: General Questions
Find older messages
Showing results 101 to 108 of 108
Search Again
Page 6 of 6