1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Jacques LeDee
    Post

    Solved feeding filament issues

    Will the parts that slide on the x-axis rods come out of the original carriage and be able to go into the new carriage? By the way, thanks for all...
    Post by: Jacques LeDee, Mar 11, 2017 in forum: Troubleshooting
  2. Jacques LeDee
    Post

    Solved feeding filament issues

    So just to be sure-before I start a model in Solid Works, everything goes and is simply replaced by the BondTech (with the e3dv6 attached to it)...
    Post by: Jacques LeDee, Mar 11, 2017 in forum: Troubleshooting
  3. Jacques LeDee
    Post

    Solved feeding filament issues

    Well, I figured it to be a horrible design and the BondTech one to be outstanding. I just want something that's not going to stop working on me,...
    Post by: Jacques LeDee, Mar 11, 2017 in forum: Troubleshooting
  4. Jacques LeDee
    Post

    Solved feeding filament issues

    Would you mind defining a couple terms for me, since I am new to this? Gregswade and build plate I will be utilizing the dictionary as well.
    Post by: Jacques LeDee, Mar 11, 2017 in forum: Troubleshooting
  5. Jacques LeDee
    Post

    Answered Bondtech QR extruder and E3d V6 hotend: How do I make these work?

    I have no problems with taking the time to design a new carriage. However, I need to know what stays on the old one and what goes? Do I design it...
    Post by: Jacques LeDee, Mar 11, 2017 in forum: Troubleshooting
  6. Jacques LeDee
    Thread

    Answered Bondtech QR extruder and E3d V6 hotend: How do I make these work?

    I have a new Bondtech QR extruder and E3d V6 hotend. I have no idea what to do with them and how to get these things on my machine and properly....
    Thread by: Jacques LeDee, Mar 11, 2017, 10 replies, in forum: Troubleshooting
  7. Jacques LeDee
    Post

    Solved feeding filament issues

    Thanks for the info. I did get with Robo and it looks like I have a bolt coming in at the end of next week. Well-I can't wait till next week. I...
    Post by: Jacques LeDee, Mar 11, 2017 in forum: Troubleshooting
  8. Jacques LeDee
    Thread

    Solved feeding filament issues

    I just got my ROBO R1+ last week. It's a refurb. the teeth on the hex bolt are bad. The filament stops feeding after about 45 minutes and the...
    Thread by: Jacques LeDee, Mar 10, 2017, 19 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 28 of 28
Search Again
Page 2 of 2