1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Hp0106
    Post

    Solved Hot end Clog

    Alright take a look at this link on how to remove the hot end. http://imgur.com/a/eLCH6
    Post by: Hp0106, Mar 19, 2016 in forum: Troubleshooting
  2. Hp0106
    Post

    Solved Hot end Clog

    Release the tension screws on the Hobbed bolt and heat up the hot end and use a pair of tweezers to get it out. If the filament is passed that...
    Post by: Hp0106, Mar 19, 2016 in forum: Troubleshooting
  3. Hp0106
    Post

    Solved Y axis jumps, sticks, screws up 90% of prints.

    Haha glad I could help. Happy printing!
    Post by: Hp0106, Mar 18, 2016 in forum: Troubleshooting
  4. Hp0106
    Post

    Solved Y axis jumps, sticks, screws up 90% of prints.

    This may sound crazy but make sure the foil isn't peeling off the bottom of the bed. Mine peeled off and got stuck to the belt which restricted...
    Post by: Hp0106, Mar 18, 2016 in forum: Troubleshooting
  5. Hp0106
    Post

    Solved printing in the air!

    My Robo had the same problem. Check to see if the z end stops are out of place and if they are check out the link below...
    Post by: Hp0106, Mar 18, 2016 in forum: Troubleshooting
  6. Hp0106
    Post

    Solved Hot end without screws Jammed!

    Take a look at this: http://imgur.com/a/eLCH6 Credit goes to Mike for this link as he posted it on a different thread
    Post by: Hp0106, Mar 17, 2016 in forum: Troubleshooting
  7. Hp0106
    Post

    Solved Bubbling on bed, where do I start?

    I've had this issue many times. Try turning the heated bed up to 55 or 60c for pla. If that doesn't work try adding a little bit of glue using a...
    Post by: Hp0106, Mar 15, 2016 in forum: Troubleshooting
  8. Hp0106
    Post

    Unresolved Extrusion problem

    Sounds like an issue with the z offset. In your case you want a larger negative number to get more space between the nozzle and the build plate so...
    Post by: Hp0106, Mar 11, 2016 in forum: Troubleshooting
  9. Hp0106
    Post

    Solved Printer started making terrible quality prints out of nowhere

    Could you post a picture of what broke? I'm no expert but since your problems started when the y axis belt clamp broke I bet that's causing your...
    Post by: Hp0106, Mar 8, 2016 in forum: Troubleshooting
  10. Hp0106
    Post

    Solved Is this possible?

    Thanks for the information I was worried about damaging the electronics but now I'm willing to proceed with my upgrades. Have a good day everyone
    Post by: Hp0106, Mar 3, 2016 in forum: General Questions
  11. Hp0106
    Thread

    Solved Is this possible?

    Hello I'm trying to put put 2 print cooling fans on my R1+. I noticed the stock fan uses .16 amps and my 2 new fans have a combined total of .36...
    Thread by: Hp0106, Mar 2, 2016, 3 replies, in forum: General Questions
Find older messages
Showing results 21 to 31 of 31
Search Again
Page 2 of 2