Separate names with a comma.
Got Marlin 2 working on my R1, and trying to use UBL. After I clear EEPROM and do G29 P1 my mesh looks like this:
Recv: Bed Topography Report:...
I have the motors working again. I had to comment out two lines in Configuration_adv.h
It seems that there is nothing wrong with the steppers, nor driver.
I can home and print with 1.1.7 (1.1.1 Mesh)
I cannot home...
So I don't have to worry about the R1 having both Z steppers on one driver where R1+ uses the E1 stepper?
The reason I ask is that I have...
Before I go attempt this, is it possible to make this work with the R1 non-plus?