1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. banolka
    Post

    newbie question on starting the journey with 3D printing

    Ok when I got home i checked the X limit switch and in fact it was triggering even not pressed so i bended a little the metal piece and now it...
    Post by: banolka, Jun 29, 2016 in forum: Troubleshooting
  2. banolka
    Post

    newbie question on starting the journey with 3D printing

    I ordered this Endstop XSS-5GL for RAMPS 1.4 RepRap [IMG]
    Post by: banolka, Jun 29, 2016 in forum: Troubleshooting
  3. banolka
    Post

    Problemy z drukiem

    Witam wszystkich. Od kilku dni jestem nowym uzytkownikiem Robo3D R1 i mam pewien problem który poruszyłem w tym temacie -...
    Post by: banolka, Jun 29, 2016 in forum: Poland
  4. banolka
    Post

    newbie question on starting the journey with 3D printing

    I pressed the end stop and it clicked on the X Axis. However i did not had a chance to check the M119 command - i will do it after work and report...
    Post by: banolka, Jun 28, 2016 in forum: Troubleshooting
  5. banolka
    Post

    newbie question on starting the journey with 3D printing

    I believe that's the one - [IMG] It is on the left side looking on the Robo 3d logo Below is the code when connected to Matter Control terminal...
    Post by: banolka, Jun 28, 2016 in forum: Troubleshooting
  6. banolka
    Post

    newbie question on starting the journey with 3D printing

    To me it is clear that instead of homecoming to left bottom my printer homes to right bottom. [IMG] Wysłane z iPhone za pomocą Tapatalk
    Post by: banolka, Jun 28, 2016 in forum: Troubleshooting
  7. banolka
    Post

    newbie question on starting the journey with 3D printing

    So i checked and no cable is blocking the bed. Bed is connected with ribbon cable to the Arduino board. Below is the video of the problem - first...
    Post by: banolka, Jun 28, 2016 in forum: Troubleshooting
  8. banolka
    Post

    newbie question on starting the journey with 3D printing

    I know so the question is why now i have different experience with the print starting?
    Post by: banolka, Jun 28, 2016 in forum: Troubleshooting
  9. banolka
    Post

    newbie question on starting the journey with 3D printing

    I have installed this one - ROBO3DR1V3_06_11_2015
    Post by: banolka, Jun 28, 2016 in forum: Troubleshooting
  10. banolka
    Post

    newbie question on starting the journey with 3D printing

    I have blue LED so i think Robo3D R1
    Post by: banolka, Jun 28, 2016 in forum: Troubleshooting
  11. banolka
    Thread

    newbie question on starting the journey with 3D printing

    Hi, I'm a new Robo3D R1 user - newbie to 3D printing. I bought used machine and ware semi successful with few first prints (cube, 1 leg for the...
    Thread by: banolka, Jun 27, 2016, 28 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 31 of 31
Search Again
Page 2 of 2