1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 4 of 4
  1. albert3d
    Post

    Community Favorite Marlin 1.1.7 Release for Robo R1, R1+PLUS & Variants

    @WheresWaldo you must not have been reading my original posts. That is exactly what I said to use G29 S-1 and it would return the M421 commands...
    Post by: albert3d, Feb 11, 2018 in forum: Mods and Upgrades
  2. albert3d
    Post

    Community Favorite Marlin 1.1.7 Release for Robo R1, R1+PLUS & Variants

    Why? It dumps it to the serial monitor on the PC. Copy paste replay man.
    Post by: albert3d, Feb 11, 2018 in forum: Mods and Upgrades
  3. albert3d
    Post

    Community Favorite Marlin 1.1.7 Release for Robo R1, R1+PLUS & Variants

    Awesome! Thank you for verifying that works! Now I won't care if I update the firmware and it wipes out my MESH down the road.
    Post by: albert3d, Feb 11, 2018 in forum: Mods and Upgrades
  4. albert3d
    Post

    Community Favorite Marlin 1.1.7 Release for Robo R1, R1+PLUS & Variants

    Oh...well under the Prepare - UBL - Output Mesh Map LCD menu, there is Off Printer Backup. Was hoping it meant I could reload. So maybe have it...
    Post by: albert3d, Feb 11, 2018 in forum: Mods and Upgrades
  5. albert3d
    Post

    Community Favorite Marlin 1.1.7 Release for Robo R1, R1+PLUS & Variants

    Anyone here ever use the output from G29 S-1 to reload a UBL mesh after a firmware update? It's a series of M421 commands. I saved mine off just...
    Post by: albert3d, Feb 11, 2018 in forum: Mods and Upgrades
  6. albert3d
    Post

    Community Favorite Marlin 1.1.7 Release for Robo R1, R1+PLUS & Variants

    Tried it again, but this time did a M500 after the M851 and it worked. They really should just make that a parameter to G26. They have...
    Post by: albert3d, Feb 4, 2018 in forum: Mods and Upgrades
  7. albert3d
    Post

    Community Favorite Marlin 1.1.7 Release for Robo R1, R1+PLUS & Variants

    @James Harry You got G26 to work? I've tried but it doesn't seem to have a parameter for setting the Z offset. Did you just issue M851 Zn.nn...
    Post by: albert3d, Feb 4, 2018 in forum: Mods and Upgrades
  8. albert3d
    Post

    Auto contol of non part fans

    What you want to do is install an RRD Fan Extender. There is a post if you search for RRD on this forum by someone named @danzca6 , but I am too...
    Post by: albert3d, Feb 4, 2018 in forum: Mods and Upgrades
Find older messages
Showing results 61 to 68 of 68
Search Again
Page 4 of 4