1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Arthur Smith
    Thread

    Answered Which is X Endstop, Y Endstop, and Z Endstop?

    In this picture, Which is the X Endstop, which is the Y endstop and which is the Z Endstop?? [IMG]
    Thread by: Arthur Smith, Mar 10, 2016, 1 replies, in forum: Troubleshooting
  2. Arthur Smith
    Post

    Answered Wiring help for Adrino after E3D V6 upgrade

    And here is the aux3 I am trying to figure out.
    Post by: Arthur Smith, Mar 10, 2016 in forum: Troubleshooting
  3. Arthur Smith
    Post

    Answered Wiring help for Adrino after E3D V6 upgrade

    So what I am needing is to know which wire to put where for the X Endstop, Y Endstop, Z Endstop, and possibly the Aux in the most lower right...
    Post by: Arthur Smith, Mar 10, 2016 in forum: Troubleshooting
  4. Arthur Smith
    Post

    Answered Wiring help for Adrino after E3D V6 upgrade

    I'd LOVE a labeled pic if someone has one!! And yes, labeling as I went would have been smart. But I so do not know what I am doing I was just...
    Post by: Arthur Smith, Mar 10, 2016 in forum: Troubleshooting
  5. Arthur Smith
    Thread

    Answered Wiring help for Adrino after E3D V6 upgrade

    I am totally lost trying to wire this after upgrading to the E3D V6. The video by Novice Expert is from the stand point of someone who knows what...
    Thread by: Arthur Smith, Mar 10, 2016, 10 replies, in forum: Troubleshooting
  6. Arthur Smith
    Post

    Solved Print head levels, moves around, but nothing prints

    I have been using Matter Control. Is there a free alternative that is better? I have been on disability and just got an extension denied so...
    Post by: Arthur Smith, Feb 28, 2016 in forum: Troubleshooting
  7. Arthur Smith
    Post

    Unresolved Easiest New/Upgrade Extruder for Robo 3d R1

    Thank you. I am printing PLA. This last time, I did us an oiler. But I'll give it a try. Thanks again
    Post by: Arthur Smith, Feb 28, 2016 in forum: Troubleshooting
  8. Arthur Smith
    Thread

    Unresolved Easiest New/Upgrade Extruder for Robo 3d R1

    Grrrr... about every other print, I was getting a clog in the hot end. Sometimes I could get it with a thin wire, other times I had to completely...
    Thread by: Arthur Smith, Feb 28, 2016, 3 replies, in forum: Troubleshooting
  9. Arthur Smith
    Post

    Solved Print head levels, moves around, but nothing prints

    It was, now its not. New issue. Thank you.
    Post by: Arthur Smith, Feb 28, 2016 in forum: Troubleshooting
  10. Arthur Smith
    Thread

    Solved Print head levels, moves around, but nothing prints

    I'm a newbie so please treat me like I'm dumb. :) I was having some jams. Got them cleared finally. Now the Robo heats up, does the auto...
    Thread by: Arthur Smith, Feb 25, 2016, 5 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 30 of 30
Search Again
Page 2 of 2