Separate names with a comma.
I wanted to buy a spare hotend just in case, is the hotend for R2 same as that of R1.
I set the Z offset to -6.85. It was saved in the EEPROM. Checked in the printer and the code. BUT when I give the command for Fine tune offset...
I went through the bed leveling procedure at the beginning of the this Troubleshooting area....
Too scared actually.
Anyways I will try the above steps today.
Do the mentioned steps applicable for R2?
Many thanks for the responses, Unfortunately, I had to stop working on the R2 printer presuming the crash.
"Just a point of interest, I...
The issue started today, on giving the command for fine-tune settings from the LCD screen, the auto-leveling is done. But then the bed goes...
No, it just switches itself off. A diode got burnt which was for the bed. I had to unplug each wire and try to find out the origination of the...
I had resolved the problem. Some malfunctioning in the PCB board. Had to replace it.
No errors were shown since the whole system restarts.
On giving the command to increase the temperature of the bed, the whole system restarts itself.
Over removing the bottom cover, found that the fuse is blown. Will replace it with a new one.
I believe that will solve the problem. Hoping...
My R2 printer is not starting when I switch it on from the back button.
By not starting I mean, no display, the fans don't turn on as they...