1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 4 of 4
  1. Gage
    Post

    Solved Z height between layers HELP

    Thanks Mark, the Z axis is no longer making such large jumps. I just need to get the auto level and first layer height adjusted and everything...
    Post by: Gage, Apr 6, 2016 in forum: Troubleshooting
  2. Gage
    Post

    E3D v6 Information, Installation Guides, and Review

    No clue on that end. I've had my robo freeze before but a power cycle brought it back up and running. Check the USB since the board on the Robo...
    Post by: Gage, Apr 6, 2016 in forum: Mods and Upgrades
  3. Gage
    Post

    E3D v6 Information, Installation Guides, and Review

    I believe if you use the stud thermistor it is the same as the factory one, at least setting wise so you would not need to change the firmware at all.
    Post by: Gage, Apr 6, 2016 in forum: Mods and Upgrades
  4. Gage
    Post

    E3D v6 Information, Installation Guides, and Review

    As Mark knows I've been struggling with getting all of the settings right with the R1 +plus. If it's powered on and the extruder temp reads 738c...
    Post by: Gage, Apr 6, 2016 in forum: Mods and Upgrades
  5. Gage
    Post

    Solved Z height between layers HELP

    Alright. Well now I have a light to look forwards to once I get home from work and can maybe start printing again. Thanks so much! I will let you...
    Post by: Gage, Apr 6, 2016 in forum: Troubleshooting
  6. Gage
    Post

    Solved Z height between layers HELP

    Default_axis_steps_per_unit {80,80,2560,723.38} Can I simply change these values?
    Post by: Gage, Apr 6, 2016 in forum: Troubleshooting
  7. Gage
    Thread

    Solved Z height between layers HELP

    I just finished installing the E3D V6 hotend on my Robo R1 +Plus. All seems to be working well and followed the instructions posted by Mike on...
    Thread by: Gage, Apr 5, 2016, 6 replies, in forum: Troubleshooting
Find older messages
Showing results 61 to 67 of 67
Search Again
Page 4 of 4