Separate names with a comma.
I will test it!
I separate some different tapes to try and discover what the UV sensor sees.
Looks the UV sensor only detects the original buildtak. If I use a magic maker on the "generic" builtak, the sensors detect it.
I did several experiments and tests to create a printing table system in which I could change it without much work.
In this way, it will be...
Looks the UV sensor simply doesn't detect it... but I will try. Maybe the sensor detects, but with a very different values.
So... I did several tests with a lot of different print surfaces and no one works.
Only the original one.
If I put any other print surface, the IR...
Yes is the last one, 1.2.6
Yep it is
Z-offset has done.
Bed calibration is done.
Auto-leveling has done.
And it still putting the bed on the wrong height.
What is the voltage from the thermistor? Also 24V?
Basically, if I found something that meets the heigh/length and fits, it works?
I found a topic...
Does anybody know what are the specs of thermistor, heater, and heat block?
I'm doing general maintenance (the old owner was not so careful) and...
Did you manage to put UBL working by default with R2?
Also, is it necessary to update merlin?
Is there a way to rework the interface and wizards, maybe using a code sequence?
The leveling by corners/middle point is automatic from the printer.
Not sure if is possible to change it or where to change it.
Actually I discovered this issue when the print bed was new.
The sensor didnt work. So I used sandpaper to "destroy" the surface and, sometimes,...
I think is related to the reflectivity of the material.
Most of the time, brighter materials worked better.
But I'm doing more research......
hahahah no problem!
I was just recording a video showing to a friend this issue with the sensor.
R2 has a mechanic sensor under the chassis where...
Anyway, until the original bed arrives here, I removed the G36 command from print start script.
The bed was hiring the heater every time.
I thought based on the ROBO staff above... "Unfortunately we are out of the IR sensors so if it is not working properly, we can disable the...